2021+ Bronco Fuse Box Lid Overlay Decal Sticker for Ford
3D Carbon (Black)
£28.49
Skip to product information
💥 We have you covered for little mods that you can do to make your Bronco unique to you. Our full print capabilities open up the door to tons of designs.
This overlay installs easily over your OEM fuse box cover. Please note the installation information contained inside this listing.
Matte finish. Fits all 2021+ Ford Broncos.
⭐ INSTALLATION ⭐
NOTES: This installation involves a textured surface. The following instructions MUST be adhered to.
HIGHLY Recommended Items:
- Microfiber cloth
- Surface cleaner
- Alcohol wipe
3D carbon fiber version is easier to install than the printed items. The material bonds better and has air egress channels. However, you should still do a proper preparation. For the 3D carbon version, no 3M promoter is included.
Clean the surface of the fuse box cover. Do not use a cleaner that contains wax. Install in 75-85 degree weather. If it is really warm, stay in the shade to control the stretching of the vinyl and drying of the fluid. You can do this install inside as well by removing the lid and letting it and the vinyl come to a warm temperature.
Do not use the promoter until the surface of the fuse box is dry. Promoter is available either as a pen or sponge. Which you receive depends on current supply. The pen has a ball inside that must be crushed before the liquid will come out. It must be used on the outer edge of the application and also the cutouts on the interior of the fuse box cover.
Do not start the application of the vinyl until the surface is once again dry. A dry install works fine for this vinyl. Align properly. Apply and use heat AND pressure to increase adhesion.
Allow the fuse box cover to heat cycle and press the edges down. Do this a few times over the course of the next few hours. If you take a drive, check for proper adhesion after the drive and press the edges down to further encourage adhesion.
2021+ Bronco Fuse Box Lid Overlay Decal Sticker for Ford
£28.49